1:14 Cab Floor With Battery Holder Merc 1851 and Gigaspace Actros

1:14 Cab Floor With Battery Holder

This item has accommadtion for the dash to be used with it

Installation method:
1, screw Kit 6 copper cylinder 6 3X6 screw at the bottom was
fixed 2 floors. If the version of the above on the second floor
to be installed servos, then the copper cylinder with 5 on the
line!
2, the second layer with a lever, 4 3X6 screws with washers
that are fixed rudder use.
3, the third layer 6 3*4 mudguards is fixed with 4 screws, on
the fourth floor is an active rod structure, fixed on the small
platform with preinstalled on a screw, silver nut loosen the
screw, lever head nut is screwed in, without tightening, some
activities, Big of that head is fixed in II floor Deputy driving bit
there has a place, with distribution of M2 screws added nut
fixed, screws loaded in lever most by outside that hole 5, fifth
layer of screws is fixed to Taiwan Board of (first two block
black of l type small iron tablets with M3X6 added nut fixed
in to Taiwan Board Shang, that is posted seat with of, Then fix
flyer's body above the middle of the two 3X6 screws
removed, replaced by we M3X10 screws, if the car behind
shell buckles shell buckle upgrade our metal cars, it is fixed
with 3X8 screw and nut, if is the original plastic one, just
down loaded plate and then put it back together), follow the
steps above, Floor boards on the base installation is complete